Filter
Top Products
Installing or removing trimmer bit
CAUTION
:
Always be sure that the tool
is
switched off and unplugged before installing or removing
the bit.
Insert the bit
all
the way into the collet
cone and tighten the collet nut securely
with the two wrenches.
To
remove the bit, follow the installation
procedure in reverse.
CAUTION
:
0
Do
not tighten the collet nut without inserting
a
bit, or the collet cone will break.
0
Use only the wrenches provided with the tool.
Adjusting bit protrusion
To
adjust the bit protrusion, loosen the
clamp screw and move the tool base up or
down
as
desired. After adjusting, tighten
the clamp screw firmly to secure the tool
base. On the tool base, there are two sight
windows through which you can read
a
graduation on the scale label. Select
a
sight
window convenient for your work and
align the scale label with the selected sight
window.
installing trimmer shoe (after it has been removed from the tool)
NOTE
:
The trimmer shoe
is
factory installed on the tool.
Use the bolts, wing nuts, spring washers
and flat washers to install the trimmer shoe
as
shown
at
right.
Wing
nut
______~~
~~
Trimmer
shoe
5