Lowepro RTA2064, RTA2072, RTR2064, RTR2072 Tiller User Manual


 
15
Section 4: Maintenance and Lubrication
7/03/07
RTA2064, RTA2072, RTR2064 & RTR2072 Rotary Tillers 311-328M
Land Pride
Table of Contents
Clutch Disassembly & Assembly
If clutch run-in procedure indicates that one or more of the
friction disks did not slip, then the clutch must be
disassembled to separate the friction disks.
NOTE: Before proceeding, secure clutch firmly in a
vise or other clamping device to prevent injury.
14232
Step 1
Remove snap ring.
Step 2
Remove backup ring, lock collar,
compression spring, bottom backup ring,
and balls.
Step 3
Tighten the four hex nuts uniformly until the
clutch pack and hub are loose.
Step 4
Bend all four retaining lugs out on the edge
of the clutch housing.
Step 5
Remove the thrust plate with the Belleville
Springs and lug rings to access friction
disks and hub for inspection or service.
Step 6
Inspect friction disks and hub.
Disassembly
14233
Step 2
Compress the Belleville Springs to the
pressure plate by tightening the four hex
nuts and then placing the assembly into the
clutch housing.
Step 3
Bend the retaining lugs inward over the
Belleville Spring edges to secure the spring
before backing the four hex nuts off.
Step 4
With the lugs bent in, loosen the four hex
nuts completely to the end of the threaded
studs.
Step 5
Insert greased balls.
Step 6
Install bottom backup ring, compression
spring, lock collar, and top backup ring.
Step 7
Install snap ring.
Step 1
Place the hub and friction disks into the
housing.
Assembly