Filter
Top Products
%&(*%$
LIMITATIONS
• The BULLDOG™ 5500 is not recommended for any
processes besides those that are normally per-
formed using stick welding (SMAW) procedures.
• The BULLDOG™ 5500 is not recommended for
pipe thawing.
• During welding, generator power is limited to 100
watts, and output voltages can drop from 120 to 80
volts and 240 to 160 volts. Therefore, DO NOT
OPERATE ANY SENSITIVE ELECTRICAL EQUIP-
MENT WHILE YOU ARE WELDING.
+""%O
CONTROLS AND SETTINGS
All welder/generator controls are located on the Output
Control Panel. Gasoline engine controls are mounted on
the engine. See Figure B.1 and the figures in engine
operation section.
-"($(*%(%$*(%")
See Figure B.1 for the location of the following features:
1. CURRENT CONTROL DIAL: Adjusts continuous cur-
rent output. The amperages on the dial correspond to
the approximate amperages needed for specific
Lincoln welding electrodes.
2. 20 AMP CIRCUIT BREAKER: Provide separate over-
load current protection for the 120 Volt and 240 Volt
Receptacles
3. WELD ELECTRODE OUTPUT TERMINAL: Pro vides
the connection point for the electrode holder cable.
4. WELD -%(! OUTPUT TERMINAL: Provides the
connection point for the work cable.
5. GROUND STUD: Provides a connection point for
connecting the machine case to earth ground.
6. 240 VOLT RECEPTACLE: Connection point for sup
240 Volt power to operate one electrical device.
7. 120 VOLT DUPLEX RECEPTACLES (2): Connection
point for supplying 120 Volt power.
8. HOUR METER: Records the time that the engine has
run for maintenance purposes.
1
2
6
7
8
5
3
4
1
2
6
7
8
5
3
4
%+*&+*&$"%$*(%")
+(