Filter
Top Products
26
Section 5: Maintenance and Lubrication
RCR1884 Series Rotary Cutters 312-880M
9/24/08
Land Pride
Table of Contents
Clutch Disassembly
Refer to Figure 5-4 on page 26:
Disassembly of the clutch is simply a matter of removing
the spring retainer nuts (#1), springs (#2) and bolts (#3)
from the assembly. Each friction disc (#4) must then be
separated from the metal surface adjacent to it.
Clutch Inspection
Inspect all parts for excessive wear and condition. Clean
all parts that do not require replacement.The original
friction disc thickness is 1/8" (3.2 mm) and should be
replaced if thickness falls below 3/64" (1.1 mm). If
clutches have been slipped to the point of “smoking”, the
friction discs may be damaged and should be replaced.
Heat build-up may also affect yoke joints.
Clutch Assembly
Refer to Figure 5-4:
Reassemble each friction disc (#4) next to the metal
plate it was separated from. Install bolts (#3) through the
end plates and intermediate plates as shown. Place
springs (#2) over the bolts and secure with nuts (#1).
Clutch Disassembly
Figure 5-4
19783
Refer to Figure 5-5:
Install new friction discs if needed and reassemble all
components in proper order. Progressively tighten each
spring retainer nut until spring length is 1.283” (1 9/32”).
Clutch Adjustment
Figure 5-5
Cutter Storage
It is good practice to clean off any dirt or grease that may
have accumulated on the cutter and on any moving parts
at the end of a working season or when the cutter will not
be used for a long period.
!
DANGER
Always disconnect main driveline from tractor PTO and secure
cutter deck in the up position with solid supports before
servicing the underside of the cutter.
1. Clean cutter of all debris.
2. Check blades for wear and replace if necessary, see
“Cutter Blade Maintenance” on page 24.
3. Inspect cutter for loose, damaged or worn parts and
adjust or replace as needed.
4. Lubricate as noted under “Lubrication” on page 27.
5. Store cutter inside when possible to prolong its life.
6. Repaint parts where paint is worn or scratched to
prevent rust. Ask your dealer for Aerosol Land Pride
touch-up paint.
24664
Land Pride Touch-up Paint
Part No. Part Description
821-011C PAINT LP BEIGE SPRAY CAN
821-032C PAINT LP GLOSS BLACK SPRAY CAN