Filter
Top Products
5
6/23/08
Manual No. 357-129M
ZXT54 Assembly Instructions
Land Pride
■
ZXT54 Assembly Instructions
ZXT54 Kit No. 357-278A
Use the list below that is for your Mulching Baffle Kit as
a checklist to inventory parts received. Please contact
your local Land Pride dealer for any missing hardware.
1. Park mower on a flat surface, move control levers
fully out, set park brake lever to on, shut engine off
and remove spark plug wire from spark plug.
2. Remove deck cover and raise front end of mower
enough to allow room to install the baffles.
Refer to Figure 5:
3. Locate pilot holes (A) which have knock-outs in the
deck. Punch-out these holes. Make sure knock-outs
are completely removed.
4. Mount baffles (#1 and #2) to the deck with
5/16"-18 x 1" GR5 round head square neck bolts (#6)
and hex whiz nut (#7). Tighten nuts to 17 ft-lbs.
5. Mount baffle (#3) to the deck with two 3/8"-16 x 1"
GR5 hex head cap screws, 3/8" flat washers and one
3/8"-16 x 3/4" round head square neck bolt (#5).
Secure bolts with 3/8" hex whiz nuts (#8). Tighten nuts
to 31 ft-lbs.
6. Lower unit and reconnect spark plug wire.
NOTE: Be sure to properly block up mower so it can
not move after it is raised.
ZXT54 Mulching Baffle Kit
Figure 5
26588
Mulching Blade Ordering
Information
MowerModel Requires 3 Blades
ZXT54 890-991C 18.77" Mulch Blade
357-278A ZXT54 MULCHING BAFFLE KIT
Your kit includes: (Note: Blades Are Not Included)
1 1 357-248H MULCH BAFFLE, FRONT, RIGHT
2 1 357-249H MULCH BAFFLE, FRONT, LEFT
3 1 357-250H MULCH PLUG
4 2 802-017C HHCS 3/8-16 x 1 GR5
5 1 802-149C RHSNB 3/8-16 x 3/4 GR5
6 4 802-282C RHSNB 5/16-18 X 1 GR5
7 4 803-043C NUT HEX WHIZ 5/16-18 PLT
8 3 803-198C NUT HEX WHIZ 3/8-16 PLT
9 2 804-012C WASHER FLAT 3/8 SAE PLT
1 357-129M MULCHING BAFFLE KIT MANUAL Z MOWER
Item Qty. Part No.Part Description