Land Pride 357-131A ZT72 Lawn Mower User Manual


 
1
© Copyright 2006 Printed
Before You Start
Your Land Pride Mulching Baffle Kit is exclusively
designed for your Land Pride Zero Turn mower. Please
read these installation instructions and the vehicle
Operator’s Manual thoroughly before beginning.
Especially read information relating to safety concerns.
Also included in the Operator’s Manual is important
information on operation, adjustment, troubleshooting,
and maintenance for this attachment (some manual
sections do not apply to all accessories).
A separate Parts Manual for replacement parts can be
purchased from your dealer or available free of charge at
www.landpride.com. Have model and serial numbers
handy when placing an order.
Manual Part Numbers:
Operator’s Manual (Z44 & Z52) . . . . . . . 357-044M
Parts Manual (Z44 & Z52) . . . . . . . . . . . 357-044P
Operator’s Manual (ZXT54 & ZXT60) . . 357-271M
Parts Manual (ZXT54 & ZXT60) . . . . . . 357-271P
Operator’s Manual (ZT60& ZT72) . . . . . 357-103M
Parts Manual (ZT60 & ZT72). . . . . . . . . 357-103P
General Information
These assembly instructions apply to the following
Mulching Baffle Kits listed below:
When you see this symbol, the subsequent
instructions and warnings are serious - follow
without exception. Your life and the lives of
others depend on it!
!
IMPORTANT: Before you begin, read these
instructions and check to be sure all parts and tools
are accounted for. Please retain these installation
instructions for future reference and parts ordering
information.
Z44 & Z52 Assembly Instructions
For Kit No’s. 357-083A & 357-084A
A detailed listing of parts for each accessory kit is
provided on page 2. Use the list that is for your Baffle Kit
as a checklist to inventory parts received. Please contact
your local Land Pride dealer for any missing hardware.
1. Park mower on a flat surface, place control levers in
park brake position, shut off engine and remove spark
plug wire from spark plug.
2. Remove deck cover and raise front end of mower
enough to allow room to install baffles.
Refer to Figure 1:
3. Locate pilot holes which have knock-outs in the deck
top. Punch-out these holes. Make sure knock-outs are
completely removed.
4. Mount baffles (#1 & #2) to the deck with 3/8"-16 x 3/4"
round head square neck bolt (#3), flat washers (#5)
and 3/8" hex nuts (#4). Tighten nuts to 20 ft-lbs.
5. Lower unit to ground and reconnect spark plug wire.
Z44 & Z52 Mulching Baffle Kit]
Figure 1
NOTE: Be sure to properly block up mower so it can
not move after it is raised.
NOTE: (Z52 S/N 472620 to 504958) A mounting
hole must be relocated for model Z52 mower
(Kit No. 357-084A). See page 2 for instructions on
drilling the “Z52 Relocated Baffle Hole”.
26616
Z44 & Z52 LP Razor; ZXT54 & ZXT60 Pro and ZT60 & ZT72 LP Accu-Z
Mulching Baffle Kit
Land Pride Zero Turn Mower
6/23/08
Manual No. 357-129M
357-083A Z44 MULCH BAFFLE KIT . . . . . . . . . . . . . . Pg. 1
357-084A Z52 MULCH BAFFLE KIT . . . . . . . . . . . . . . Pg. 1
357-278A ZXT54 MULCH BAFFLE KIT . . . . . . . . . . . . Pg. 5
357-135A ZXT60 MULCH BAFFLE KIT . . . . . . . . . . . . Pg. 4
357-130A ZT60 MULCH BAFFLE KIT (S/N 505070-) . Pg. 3
357-135A ZT60 MULCH BAFFLE KIT (S/N 505071+) . Pg. 4
357-131A ZT72 MULCH BAFFLE KIT (S/N 510757-) . Pg. 3
357-136A ZT72 MULCH BAFFLE KIT (S/N 510758+) . Pg. 4
Tools required
Basic hand tools
Definitions
Right-hand and left-hand as used in this manual is
determined by facing the direction the machine will
operate while in use unless otherwise stated.