Filter
Top Products
2
Manual No. 356-141M 1/16/07
Land Pride
Instructions For Kit No 356-142A
■
Refer to Figure 3:
6. Locate main wiring harness attached to the mower
frame. Cut plastic ties securing harness in place.
Locate Wire Harness
Figure 3
Refer to Figure 4:
7. Pull white connector out from under back right corner
of mower frame.
8. Unplug connector by pressing down on the center
tab and pulling the two ends apart.
Unplug Connector
Figure 4
Refer to Figure 5 & Figure 6:
9. Locate two purple ground wires leading from the
connector to the main wiring harness.
Remove Purple Ground Wires
Figure 5
Main Wiring
Harness
23813
Plastic Tie
Mower Frame
Male End
23814
Press Here to
Unplug Connector
Female End
23815
Purple Wire
Backside of
Connector
Main Wiring
Harness
10. Insert terminal removal tool or small thin bladed
screw driver into backside (see Figure 5) of a purple
wire connector slot. Push in on the purple wire and
press down on the holding tab. See Figure 6 below
for view of holding tab. Once the tab has released,
pull purple ground wire out. If the terminal does not
release, reposition terminal tool and pull on the wire
again.
Spade Terminal Holding Tab
Figure 6
11. Repeat step 10 to remove second purple ground
wire.
Refer to Figure 7:
12. Cut both purple wires close to the spade terminals.
Cutting close will leave enough wire to install butt
connector in step 13 below.
Cutting Spade Terminals Off
Figure 7
Refer to Figure 7:
13. Strip 3/8" length of outer covering from both ends of
purple ground wires. Twist wire ends together and
twist-on butt connector.
Installing Butt Connector
Figure 7
Spade Terminal Holding Tab
24595
23816
Spade
Terminals
Wire Cutters
Cut Close
to Spade
Terminals
23819
Butt
Connector
Main Wiring
Harness
Two Purple
Ground Wires