Filter
Top Products
14
VII. ADDING REMOTE TEMPERATURE SENSORS (OPTIONAL)
The WS-9075U is able to receive signals from 3 different remote temperature sensors. The remote
temperature sensor model(s) that you choose will come with their own set of instructions—follow these
instructions for a complete guide to setting up. Following are some brief instructions for the basic set-up
of remote temperature sensor units with the WS-9075U. These extra sensors can be purchased through
the same dealer as this unit, or by contacting La Crosse Technology directly. A TX6U will monitor
temperature only, a TX3U will monitor temperature and display the temperature on its LCD, and the
TX3UP will monitor the temperature via a probe for use in pools, spas, etc.
Note: When setting up multiple units it is important to remove the batteries from all existing units in
operation, then to insert batteries first into all the remote temperature sensor units, and in numeric
sequence. Second install batteries into the indoor weather station. Transmission problems will arise if
this is not done correctly and if the total time for set-up exceeds 4 minutes.
A. SET-UP OF MULTIPLE UNITS
1. It is necessary to remove the batteries from all units currently in operation.
2. Remove the battery covers to all remote temperature sensor units.
3. Place all remote temperature sensor units in a numeric sequential order.
4. In sequential order, install batteries (follow the same battery installation procedures seen in
section I. A) of the Detailed Set-Up Guide).
5. Install batteries into the indoor weather station.
6. Follow the Detailed Set-Up Guide for programming and operating instructions.
B. VIEWING AND OPERATING WITH MULTIPLE REMOTE TEMPERATURE
SENSOR UNITS
1. To view the temperature of a different remote temperature sensor unit, press and release the
CHANNEL button. A shift from one “boxed” number to the next should be observed in the
OUTDOOR LCD.
2. To view the Minimum/Maximum temperature: first select which remote temperature sensor
to read data from (indicated by the “boxed” number), then press the MIN/MAX/+ button. To
view the readings from different transmitters, follow IV. A. Viewing the Outdoor
Temperature Records paragraph above.
3. To reset the Minimum/Maximum readings, select first which remote temperature sensor to
read data from. Press the MIN/MAX/+ button to view the outdoor MIN/MAX records. Then
follow the steps in IV. C. Resetting the Minimum and Maximum Records paragraph
above.