Filter
Top Products
6
A. THERMO-HYGRO SENSOR
1. Remove the Protective Rain Cover.
2. Remove the Battery Cover.
3. Observing the correct polarity, install 2 “AA” Alkaline Batteries—make sure they
do not spring free, or start-up problems may occur. Replace the Battery Cover.
B. WIRELESS WEATHER STATION
Note: After the batteries are installed, DO NOT press any buttons. This may interfere
with the signals, causing temperatures to register incorrectly.
1. Remove the Battery Cover on the back of the Wireless Weather Station.
2. Observing the correct polarity, install 2 “AA” Alkaline Batteries.
3. Replace Battery Cover.
4. Wait 15 minutes before pressing any buttons.
* When the signal is successfully received by the Weather Station, the icon will be
switched on. (If not successful, the icon will not be shown in LCD) So the user can
easily see whether the last reception was successful (icon on) or not (icon off). On the
other hand, the short blinking of the icon shows that a reception is being done now.
C. SELECTING 12 OR 24 HOUR TIME DISPLAY
1. Press and hold the SET/CH button for about 5 seconds.
Battery
Cover
Rain protection
cove
r
Battery
Compartment
Sensor signal
reception icon*
Battery
Compartment
Battery
Cove
r