Filter
Top Products
2
BATTERY
COMPARTMENT
INITIAL SETUP (USING INCLUDED SOLAR RECHARGEABLE BATTERIES FROM THE FACTORY)
1. Open battery compartment on the back of the Weather Station and make sure that the battery switch
under the battery compartment is to the left. If it is not, please slide the switch to the left before
proceeding.
2. Locate the battery insulator tab and gently pull to remove it.
3. Slide the battery switch to the SOLAR position.
4. Continue to section labeled "ACTIVATE SOLAR-POWERED OUTDOOR TRANSMITTER"
ACTIVATE SOLAR-POWERED OUTDOOR TRANSMITTER
Press the RESET key on the Sensor to activate the solar-powered transmitter and place it 5-10 feet
from the Weather Station for 15 minutes. The outdoor temperature will show on the weather station
within 60 seconds. Allow the sensor and the weather station to sit 5-10 feet apart for 15 minutes so the
signal can lock in repeatedly. Do not press buttons at this time.
NOTE: The solar panel needs light from a 60W light bulb or brighter during the activation process. Do not
cover solar panel with hands or other objects.
TX62UTH-IT transmitter RESET key:
NOTE: Do not use sharp objects to
press the RESET key. Use a small
dull pointed object or a straightened
paper clip and
gently press the
RESET key to commence NORMAL
MODE.
Several start up numbers will flash on
the screen of the sensor then the
temperature will display.
RESET key
SWITCH RIGHT
(SOLAR OPERATION)
(SOLAR-RECHARGEABLE
BATTERIES)
Slide switch to RIGHT
position once solar-
rechargeable
batteries are inserted and
insulator tab is removed
WARNING
Do NOT recharge the
included solar-
rechargeable batteries
outside of this product
because it will damage
the batteries and other
charging devices.
SWITCH LEFT
(START-UP / RESET)
(STANDARD
ALKALINES)
Slide switch to LEFT
position before (1) start-
up / reset or (2) any type
of battery replacement