Filter
Top Products
8
ALARM SET:
Hold the ALARM button for 5 seconds to enter the alarm time set mode.
1. The alarm hour digit will flash.
2. Press and release the +/RCC or -/°C/°F button to select the hour.
3. Press and release the SET button to set the minutes. The minute
digits will flash.
4. Press and release the +/RCC or -/°C/°F button to select the
minutes.
5. Confirm with the SET button and exit.
6. The alarm icon will show above the minutes indicating the alarm is active.
7. The alarm icon will flash when the alarm is sounding.
DEACTIVATE ALARM:
1. Press and release the ALARM button once to show Alarm Time.
2. Press and release the ALARM button to deactivate the Alarm. The alarm icon will disappear
indicating the alarm is no longer active.
SNOOZE:
1. When the alarm sounds, press the SNOOZE/LIGHT button to trigger snooze alarm for 10 minutes.
The snooze icon Zz will flash when the snooze feature is active.
2. To stop alarm for one day, press ALARM button, while in snooze mode. The alarm icon will remain
solid.
Note: When the alarm sounds, it continues for 2 minutes and then shuts off completely.
USB CHARGE PORT:
The integrated USB charging port (on back) will charge devices when the Weather Station is plugged into
a power outlet.
For example: you can use the USB charge cord to connect your cell phone to the USB charge port on
the back of the Weather Station and allow your phone to charge. The Weather Station must be operating
with a/c power in order to charge your device.
DO NOT try to charge the weather station by connecting a USB cable from the Weather Station to your
computer etc. This is an output port only.
Connect your existing USB charging cord for your external device
to the USB charging port on the back of the Weather Station to
begin to charge. Charging times will vary.
Note: Check that your device will charge with the USB cord it came
with. Many USB cords are for data transfer only, and cannot be
used for charging.
Output: 1A maximum current USB.
Do NOT overload USB port.
Note: This is a power output (charging) port only. This port will
not supply power to the Weather Station.
IMPORTANT: When operating on a/c power, to avoid interference, the backlight and USB charge port
will turn off while the Weather Station searches for the WWVB signal. The backlight and USB charge port
resume after a 2-10 minute search which occurs during the late night or early morning hours.