TP-6843 1/13 Section 3 VSC Controller Operation 33
3.12 Generator Set Information
Menu
The generator set model number and serial numbers
are displayed (see Figure 3-13). No changes are
allowed from this menu.
Model and serial numbers are factory-set and should
not require changes in the field, except in the event
that the controller is being replaced. A personal
computer running Kohler
®
SiteTech
™
software is
required to enter the generator set model number and
serial numbers on a replacement controller. Contact
an authorized Kohler distributor/dealer for service.
Figure 3-13
Figure 3-13 Generator Set Information Menu
3.13 Genset Run Time Menu
The data shown in Figure 3-14 are displayed. No
changes are allowed from this menu.
The Next Maintenance menu shows the number of
hours of generator set operation until maintenance is
required. The estimated date for the next scheduled
maintenance is also displayed. The maintenance
reminder intervals are based on the engine
manufacturer’s recommendation for changing the oil.
See Section 4, Scheduled Maintenance, for
maintenance instructions.
After changing the oil and performing other
recommended maintenance, go to the Overview menu
to reset the maintenance timer. See Section 4.2.5 for
instructions to reset the maintenance timer.
Figure 3-14
Figure 3-14 Generator Set Run Time Menu
tp6804
Genset M/N:
6VSG-48V
Genset S/N:
Controller S/N:
<---- Return
Genset ---->
Information
########
########
tp68
Eng Runtime:
100.6 h
Eng Starts:
127
<---- Return
Genset ---->
Run Time
Next Maintenance:
150 h or Mar2012