Filter
Top Products
Safety Precautions and Instructions V
TP-6335 9/04
Airborne particles.
Can cause severe injury or
blindness.
Wearprotectivegogglesandclothing
when using power tools, hand tools,
or compressed air.
WARNING
Tightening the hardware. Flying
projectiles can cause severe injury
or death. Loosehardware can cause
the hardware or pulley to release from
thegeneratorsetengineandcancause
personal injury. Retorque all
crankshaft and rotor hardware after
servicing. Donotloosenthecrankshaft
hardwareorrotorthruboltwhenmaking
adjustments orservicing the generator
set. Rotate the crankshaft manually in
a clockwise direction only. Turning the
crankshaft bolt or rotor thrubolt
counterclockwise can loosen the
hardware.
Servicing the generator set when it
is operating. Exposed movingparts
can cause severe injury or death.
Keep hands, feet, hair, clothing, and
test leads away from the belts and
pulleys when the generator set is
running. Replaceguards,screens,and
covers before operating the generator
set.
Notice
NOTICE
This generator set has been
rewiredfromitsnameplatevoltage
to
246242
NOTICE
Voltage reconnection. Affix a notice
to the generator set after reconnecting
the set to a voltage different from the
voltage on the nameplate. Order
voltage reconnection decal 246242
from an authorized service
distributor/dealer.
NOTICE
Hardware damage. The engine and
generator set may use both American
Standard and metric hardware. Use
the correct size tools to prevent
rounding of the bolt heads and nuts.
NOTICE
When replacing hardware, do not
substitute with inferior grade
hardware. Screws and nuts are
available in different hardness ratings.
To indicate hardness, American
Standard hardware uses a series of
markings, and metric hardware uses a
numeric system. Check the markings
on the bolt heads and nuts for
identification.
NOTICE
Canadian installations only.For
standby service connect the output of
the generator set to a suitably rated
transfer switch in accordance with
Canadian Electrical Code, Part 1.
NOTICE
This generator set does not comply
with United States Coast Guard
(USCG) requirements and must not
beused for marine applications. For
marineinstallations use onlygenerator
sets specified for marine use. USCG
Regulation 33CFR183 requires that a
generator set must be ignition
protected when used in a
gasoline-fueled environment.