Kohler 116347-2 Outdoor Shower User Manual


 
116347Ć2ĆAA (A)
Kohler Co., Kohler, WI19
INSTALL CEMENT BOARD
Install cement board to the walls according to
established installation methods. The cement
board must cover the entire wall surface from
ceiling to subfloor. Provide a cutĆout area around
the mounting frame.
Mark the cement board for the suction fitting hole
by first measuring up at least 2Ć1/2Ćinches from
the footbath basin material. Add the thickness of
the finished floor material you plan to use, and
draw a pencil mark at that location. Make sure the
wall is perfectly flat and smooth within a 5Ćinch
diameter area around the suction hole pencil
mark. Use a hole saw to drill a 3Ć1/4Ćinch hole in
the cement board at the pencil mark.
Carefully cut holes for the water supplies, suction,
drain and drain overflow, as well as any lighting
fixtures or other required accessories.
Cut a hole around the keypad outlet box, if used. If
you are not using the outlet box, cut or drill a
1Ć1/8Ćinch diameter hole for the cable.
CONSTRUCT FOOTBATH BASIN
Construct the footbath basin according to your
specific BodySpa room design. Employ established
shower basin fabrication materials and techniques.
Provide a 1/4 to 1/2Ćinch per foot pitch to the
footbath basin floor for the correct floor drainage.
Locate and cut the drain and drain overflow holes
according to the instructions packed with the drain.
The KĆ7179 Drain has been specially designed for the
Custom BodySpa, and is recommended for use with
this installation. The installation instructions
included with the KĆ7179 Drain provide detailed
instructions for this installation. Install the drain
flange according to the drain instructions.
INSTALL WATERĆRESISTANT WALL
MATERIAL
Install waterĆresistant wall material to the entire
ceiling surface according to established methods.
Check Point #7
- Waterproofing membrane or compound installed.
- Suction bushing installed.
- Cement board installed to subfloor and walls.
- Required holes marked and cut in cement board.
- Confirm footbath basin floor pitch of 1/4 to 1/2Ćinch per foot.
INSTALLATION
INSTALLATION