Filter
Top Products
ATTACHING TO TRACTOR
WARNING
Never stand between
tractor and rotary tiller
while backing up tractor
to the hitch.
STEP 1
Attach to tractor's category 1 three point hitch as described in the
Tractor's Operator’s Manual.
STEP 2
Determine if the PTO shaft needs to be shortened.
NOTE:
Due to the many variations in the tractor hitch points and dis-
tances between equipment gearbox input shaft and tractor PTO
out put shafts, some combinations may require PTO shafts to be
shortened as described by the following steps.
STEP 3
Raise and lower rotary tiller in order to locate the shortest distance be-
tween equipment gearbox input shaft and tractor PTO output shaft.
With the rotary tiller in the shortest distance position shut down the trac-
tor and SECURELY BLOCK ROTARY TILLER IN POSITION.
WARNING: IF TILLER IS RAISED UP SO THAT PTO SHAFT IS AT AN ANGLE
SHARPER THAN 35 DEGREES PTO MUST BE STOPPED!
16