Filter
Top Products
MAINTENANCE
Reel Drive Belts.
When fitting Belts to Reels 2 or 3, the Main Drive Belts and
the Jackshaft Couplers, must be removed first. See page 37.
To keep the Compression Tool clear of the Stay Rod the
Binder Collar and Chain may be used.
CAUTION
When the Binder Collar is used check it is firmly in place
on the ¾ nut, before compressing the Telescopic Arm.
To replace the Reel Drive Belts. Reels 1, 4 and 5. :
Fig.33
• Remove the Safety Chain at the Stay Rod. Attach
the Release Tool. Compress the Telescopic Arm.
• Remove Tie Rod from the Reel.
• Carefully release the Compression Tool to fully
expand the Telescopic Arm.
• Pull the Reel ‘out’, to separate the Telescopic Arm,
and remove the belt.
• Install new Drive Belt and re-assemble in the
reverse order.
CAUTION
Telescopic Arms are heavily spring loaded.
Exercise extreme care when compressing them to avoid
serious injury.
Fig.33
38