Filter
Top Products
7.Attachthe Reflectoronto EmitterGridby
using4 of the 1/4" SpringWashersand 1/4"
Wing Nutsprovided.See Fig. 4.
8. SlidetheTankCoverthroughthe LowerPost
and onto the WeightedBase.See Fig. 5.
9. Lift the assembled Upper Post and insert the
balance of the Fuel Hose through Lower Post.
10. Keep the Upper Post slightly lifted and turn it
until its screw hole faces the same direction
as the sliding channel of the Lower Post.
Slide Upper Post into Lower Post, until the
holes on both posts align. Tighten securely
using 1 of the T4x15 Self-Tapping Screws
provided.
11. Raise the Tank Cover and tilt it sideways until
it rests onto the bracket of the Lower Post.
Connect the hose end fitting of the Regulator
Assembly to the stainless steel Fuel Hose.
Tighten securely with two adjustable wrenches.
12. Carefully bend the stainless steel Fuel Hose
at a 90 degree angle. Hold the connected
hose fittings against the installed Hose Holder
A, and secure Hose Holder B to Hose Holder
A by inserting the Fastening Strip into the
slot of Hose Holder A. Tighten firmly using
the 3/16"xl/2" Phillips Head Screw, and the
3/16" Spring Washer and 3/16" Nut provided.
Use adjustable wrench to tighten the Nut.
Figure 4
EMITTER
Figure 5
SLIDING CHANNEL
TANK COVER
I
STAINLESS
FUEL HOSE
UPPER POST
f"
LOWER POST
jJ
BRACKET
HOSE HOLDER B
FASTENING STRIP
BELOW
REGULATOR ASSEMBLY
HOSE HOLDER A
(previouslyinstalled)
SLOT FOR
FASTENING STRIP
11