Filter
Top Products
4 English
Note: Always use Kärcher water filter
(order no. 4.730-059.0) during suction
operations of the pressure washer.
Note: Outdoor surfaces should be
swept before the T-Racer is used to
avoid damaging the nozzles.
Connect the T-Racer and both wands
with the trigger gun.
Illustration
Î Connect lower wand with T-Racer.
1 Press the bayonett connection into
the bayonet catch, then turn by 90°
until it locks into place.
2 Tighten the union nut.
Î Connect upper wand with lower
wand.
1 Press the bayonett connection into
the bayonet catch, then turn by 90°
until it locks into place.
2 Tighten the union nut.
Î Connect trigger gun with upper
wand.
1 Press the bayonett connection into
the bayonet catch, then turn by 90°
until it locks into place.
2 Tighten the union nut.
Illustration
ṇ Caution
Do not run over freestanding corners.
Connect the T-Racer and the lower
wand with the trigger gun.
Illustration
Î Connect lower wand with T-Racer.
1 Press the bayonett connection into
the bayonet catch, then turn by 90°
until it locks into place.
2 Tighten the union nut.
Î Connect trigger gun with lower wand.
1 Press the bayonett connection into
the bayonet catch, then turn by 90°
until it locks into place.
2 Tighten the union nut.
ƽ Caution
Always hold the T-Racer at the hand
grip while cleaning the walls.
Do not reach under the edge of the
T-Racer while the device is in opera-
tion.
Application
Cleaning horizontal surfaces
Cleaning vertical surfaces