Filter
Top Products
12
TROUBLESHOOTING – continued
Solution
Check connection.
Dilute detergent, for best results
use Kärcher detergent.
Run warm water through filter to
remove debris.
Remove obstruction or replace
detergent suction tube.
Turn spray wand tip to low
pressure position.
Blow out or remove debris with
fine needle.
Tighten fittings.
Insert new washer.
Insert the spray wand into the
spray wand extension. Carefully
press in against the spring tension
and twist into the locked position.
Slide the spray wand extension
into the gun. Turn the wand
collar clockwise onto the gun
threads until tight.
Call Kärcher customer service
“hotline and order repair kit “(part
no. 2.883-111.0).
Check that hoses and fittings are
air tight. Turn off machine and
purge pump by squeezing trigger
gun until “a steady flow of water
emerges through the nozzle.
Check that all fittings are tight.
Call service center.
Call service center.
Symptom
No detergent.
Garden hose
connection leaks.
Spray wand or Spray
wand extension leaks.
Pump is noisy.
Water leaks from pump (up
to 10 drops per minute is
permissible).
Oil Drip.
Cause
Detergent suction tube not properly
connected to the machine.
Detergent is too thick.
Filter on detergent suction tube is
clogged.
Damaged or clogged detergent
suction tube.
Spray wand is in high“pressure
position.
Discharge nozzle is obstructed.
Loose fittings.
Missing/worn rubber washer.
Spray wand not properly attached.
Spray wand extension not properly
attached.
Broken o-ring or plastic insert.
Pump is sucking air.
Loose fittings.
Water seals are damaged or worn.
Oil seals are damaged or worn.
If you encounter any additional difficulties not listed, please
call our service center for help.
Karcher Customer Support USA
1-800-537-4129