Filter
Top Products
9
WINTERIZING AND LONG-TERM STORAGE – continued
5) Cleaning the
water inlet filter
Pull out the water in-
let filter with flat-nose
pliers and rinse out in
warm water.
Maintenance
The unit is
maintenance-free.
6) Cleaning the
detergent inlet filter
Pull it out and rinse out
in warm water.
CLEANING TIPS
Deck Cleaning
(with or without detergent)
Pre-rinse deck and surrounding area with
fresh water. If using Kärcher Deck + Fence
Wash, apply to surface at low pressure. For
best results, limit your work area to smaller
sections of approximately 25 square feet.
Allow Deck Wash to remain on surface 1-3
minutes. Do not allow detergent to dry on
surface. Rinse at high pressure in a long
sweeping motion keeping the spray nozzle
approximately 3-6 inches from the cleaning
surface. Always clean from top to bottom
and from left to right. When moving on to a
new section of the cleaning surface, be sure
to overlap the previous section to eliminate
stop marks and ensure a more even cleaning
result.
Caution: Do not use rotary spray wand on
wood surfaces as it may cause damage.
House Siding
(with or without detergent)
Pre-rinse cleaning surface with fresh water. If
using Kärcher Pressure Wash, apply to
surface at low pressure (for best results,
limit your work area to sections of
approximately 6 feet and always apply
detergent from bottom to top). Allow
Pressure Wash to remain on surface 1-3
minutes. Do not allow detergent to dry on
surface, if surface appears to be drying,
simply wet down surface with fresh water. If
needed, use special wash brush attachment
(not included) to remove stubborn dirt. Rinse
at high pressure from top to bottom in an
even sweeping motion keeping the spray
nozzle approximately 6 inches from the
cleaning surface.
Caution: Do not use rotary spray wand on
siding as it may cause damage.
Cement Patios, Brick and
Stone
(with or without detergent)
Pre-rinse cleaning surface with fresh water. If
using Kärcher Pressure Wash or Degreaser,
apply to surface at low pressure. For best
results, limit your work area to smaller
sections of approximately 25 square feet.
Allow Pressure Wash or Degreaser to remain
on surface 1-3 minutes. Do not allow
detergent to dry on surface. Rinse at high
pressure in a sweeping motion keeping the
spray nozzle approximately 3-6 inches from
the cleaning surface. Always clean from top
to bottom and from left to right.
For removing extremely stubborn stains,
use the rotary spray wand.
Cars, Boats & Motorcycles
(with or without detergent)
Pre-rinse vehicle with fresh water. If using
Kärcher Vehicle Wash, apply to surface at
low pressure. For best results, clean one
side of vehicle at a time and always apply
detergent from bottom to top, do not allow
detergent to dry on surface. If needed, use
special wash brush attachment (not
included) to remove stubborn dirt. Rinse at
high pressure in a sweeping motion keeping
the spray nozzle approximately 6-8 inches
from the cleaning surface (distance should
increase when rinsing pin-striping or other
sensitive surfaces). Always clean from top to
bottom and from left to right. For best
results, wipe surface dry with a chamois or
soft dry cloth.
Caution: Do not use the rotary spray
wand on vehicles as it may cause
damage.