Filter
Top Products
English – 9
ASSEMBLY
Fitting the main body
Connect the engine (A) to the tube (B) with four screws (C).
Connecting throttle cable and stop
switch wires
1 Insert the throttle cable (A) through the carburettor bracket
(B), then screw the cable adjuster sleeve (C) into the
carburettor bracket fully.
2 Position the slotted fitting (D) on the carburettor so the
recessed hole (E) for the cable lug (F) is away from the
cable adjuster sleeve.
3 Rotate the carburettor throttle cam and slip the throttle
cable through the slot in the slotted fitting, making sure the
cable lug drops into the recessed hole.
4 Operate the throttle trigger a few times to make sure that
it works correctly.
5 Adjust the cable adjuster sleeve so the stop on the
carburettor throttle cam just contacts the throttle stop and
the cable position keep 1-2 mm play between the cable
lug and the slotted fitting when the throttle trigger is fully
depressed.
6 When the throttle cable is adjusted correctly, tighten the
locking nut (G).
7 Plug the stop switch wires (H) into the matching
connectors from the engine. Note that wire polarity is not
important.
Fitting the handle
1 Position the handle on the shaft. Note that the handle
must be mounted below the arrow on the shaft.
2 Attach the J-handle to the loop handle using the 4 screws,
as shown.
3 Now make a final adjustment, with the machine hanging
from the harness, to obtain the most comfortable working
position. Tighten the screws.
A
B
C
1-2mm