Filter
Top Products
2
–
English
KEY
T
O SYMBOLS
Symbols
W
ARNING! Incorrect or careless use of
a hedge trimmer can turn it into a
dangerous tool that can cause serious or
even fatal injury. It is extremely important
that you read and understand the
contents of this operator’s manual.
Please read the operator’s manual carefully
and make sure you understand the
instructions before using the machine.
Always wear:
• Approved hearing protection
• Approved eye protection
This product is in accordance with
applicable EC directives.
Cutting tool.
Do not touch the tool
without first switching off the engine.
This machine is not electrically
insulated. If the machine touches or
comes close to high-voltage power lines it
could lead to death or serious bodily
injury. Electricity can jump from one point
to another by arcing. The higher the
voltage, the greater the distance
electricity can jump. Electricity can also
travel through branches and other objects,
especially if they are wet. Always keep a distance of at least
10 m between the machine and high-voltage power lines and/
or any objects that are touching them. If have to work within
this safe distance you should always contact the relevant
power company to make sure the power is switched off before
you start work.
This machine can be dangerous! The operator of the machine
must ensure, while working, that no persons or animals come
closer than 15 metres.
Arro
ws which show limits for handle
positioning.
Alw
ays wear approved protective gloves.
W
ear sturdy, non-slip boots or shoes.
Noise emission to the en
vironment according
to the European Community’s Directive. The
machine’s emission is specified in chapter
Technical data and on label.
Other symbols/decals on the mac
hine refer to special
certification requirements for certain markets.
The engine is s
witched off by moving the
stop switch to the stop position. NB! The
stop switch automatically returns to the
start position. In order to prevent
unintentional starting, the spark plug cap
must be removed from the spark plug when
assembling, checking and/or performing maintenance.
Always wear approved protective gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must be worn.