Jonsered GC 2125 Brush Cutter User Manual


 
24 English
TECHNICAL DATA
Technical data
Note 1: Equivalent noise pressure level is calculated as the time-weighted energy total for noise pressure levels under various
working conditions with the following time distribution: 1/2 idle and 1/2 max. speed.
NOTE! Noise pressure at the users ear and vibration on the handles are measured with all the machines approved cutting
equipment tted. The table indicates the highest and lowest values.
Technical data GT 2125 GC 2125
Engine
Cylinder volume, cu.in/cm
3
1,50/24,5 1,50/24,5
Cylinder bore, inch/mm 1,26/32 1,26/32
Stroke, inch/mm 1,06/27 1,06/27
Idle speed, rpm 2700 2700
Recommended max. speed, rpm 11000-11700 11000-11700
Speed of output shaft, rpm 11700 8014
Max. engine output, acc. to ISO 8893, kW/ r/min 0,9/9000 0,9/9000
Catalytic converter mufer No No
Speed-regulated ignition system Yes Yes
Ignition system
Manufacturer/type of ignition system WalbroMB/SEM AM49 WalbroMB/SEM AM49
Spark plug
NGK BPMR 7A
Champion RCJ 7Y
NGK BPMR 7A
Champion RCJ 7Y
Electrode gap, inch/mm 0,02/0,5 0,02/0,5
Fuel and lubrication system
Manufacturer/type of carburettor Zama C1Q Zama C1Q
Fuel tank capacity, US pint/litre 1,06/0,5 1,06/0,5
Weight
Weight without fuel, cutting attachment and guard, Lbs/kg 9,0/4,1 9,0/4,1
Sound levels
(see note 1)
Equivalent sound pressure level at the users ear,
measured according to ANSI B175.3-1997, dB(A), min/
max:
94/94 93/99
Vibration levels
Vibration levels at handles, measured according to ANSI
B175.3-1997, m/s
2
At idle, left/right handles, min.: 2,3/1,0 1,0/1,1
At idle, left/right handles, max.: 2,3/1,0 1,4/1,3
At max. speed, left/right handles, min.: 3,4/3,9 3,0/6,0
At max. speed, left/right handles, max.: 3,4/3,9 4,5/7,3