Jonsered CS 2147 Chainsaw User Manual


 
English – 35
MAINTENANCE
Note! The cooling system on a chain saw with catalytic
converter must be cleaned daily. This is particularly important
on chain saws with catalytic converters, because the higher
exhaust temperature requires efcient cooling of the engine
and the catalytic converter unit.
”Air Injection” centrifugal cleaning
Centrifugal cleaning means the following: All air to the
carburettor passes through the starter. Dirt and dust is
centrifuged out by the cooling fan.
IMPORTANT! In order to maintain operation of the centrifugal
cleaning system it must be regularly maintained. Clean the air
intake to the starter, the ns on the ywheel, the space around
the ywheel, inlet pipe and carburettor compartment.
Winter use
Running problems can occur when using the machine in the
cold and snowy conditions caused by:
Too low engine temperature.
Icing of the air lter and carburettor.
Special measures are therefore often required:
Partly mask the air inlet on the starter to increase the
working temperature of the engine.
Preheat the intake air to the carburettor by using the heat
from the cylinder.
Temperature 0°°
°°
C or colder:
The cylinder cover is designed so it can be adjusted for
running in cold weather. Twist the winter ap so that
preheated air from the cylinder can pass into the carburettor
space preventing icing of the air lter, etc.
For temperatures below -5°C and/or in snow conditions there
is also:
a special cover (A) for the starter housing
a winter plug (B) for the air nozzle that is tted as shown.
These reduce the ow of cooling air and prevent large
amounts of snow from being sucked into the carburettor
space.
CAUTION! When the winter plug is tted the winter ap must
be open!
Heated handles
(CS 2147W, CS 2152W)
On models with the designation XPG/G, the front as well as
the rear handle are equipped with electric heating coils.
These are supplied with electricity from a built-in generator on
the chain saw.
When the switch is pushed downwards, the heat is switched
on. When the switch is pushed upwards, the heat is switched
off.
Electrical carburettor heating
(CS 2147WH, CS 2152WH)
On models with the designation CARBURETOR HEATING
there is an electrically heated carburetor. Electrically powered
heating prevents ice formation in the carburetor. A thermostat
regulates the heating so that the carburetor always has the
right working temperature.
IMPORTANT! If the temperature rises above -5°C or 0°C
respectively the machine MUST be restored to its normal
set-up. Otherwise there is a risk of overheating, which can
cause severe engine damage.
H
H