22 – English
STARTING AND STOPPING
Start throttle: (FC 2145, FC 2145 S, FC 2145 W, BC 2145,
CC 2145)
Set the throttle to the start position by moving the choke
control to the choke position and then returning it to its original
position.
If the machine is fitted with a decompression valve (A): Press
the valve to reduce the pressure in the cylinder and make
starting easier. You should always use the decompression
valve when starting the machine. Once the machine has
started the valve will automatically return to its original
setting.
Starting
Hold the body of the machine on the ground using your left
hand (CAUTION! Not with your foot!). Grip the starter handle,
slowly pull out the cord with your right hand until you feel
some resistance (the starter pawls grip), now quickly and
powerfully pull the cord. Never wrap the starter cord around
your hand
Repeat pulling the cord until the engine starts. When the
engine starts. return choke control to run position and apply
full throttle; the throttle will automatically disengage from the
start setting.
CAUTION! Do not pull the starter cord all the way out and do
not let go of the starter handle when the cord is fully extended.
This can damage the machine.
Stopping
Stop the engine by switching off the ignition.
Heated handles (FC 2145 W)
Models equipped with heating elements in the handles have
an on/off switch on the throttle handle to control the heat. Both
the left and right handles have heating elements that
automatically maintain a temperature of roughly 70
° when the
heat is turned on.
!
WARNING! When the engine is started with
the choke in either the choke or start throttle
positions the cutting attachment will start to
rotate immediately.
BC 2145, CC 2145
FC 2145