Filter
Top Products
1. Implement is completely assembled.
2. Gearbox lled with oil and checked for possible leaks. (See page 29)
3. All ttings lubricated. (See page 20 - 21)
4. All shields in place and in good condition.
5. All fasteners torqued to speci cations in Torque Chart. (See page 32)
6.
Check PTO driveline. Make sure it is the correct length to operate
rotary cutter
with intended tractor. (See page 16)
7.
Check front of input gearbox shaft and make sure that snap ring is
properly installed (PTO shaft shear pin only).
8.
Check shear/retaining bolt for proper grade and installation. (See page 23, 24
and 37)
9. All decals in place and readable. (See page 8)
10. Overall condition good (i.e. paint, welds)
11. Operator’s manual has been given to owner and the owner has been
instructed
on the safe and proper use of the rotary cutter.
Dealer’s Signature
Purchaser’s Signature
THIS CHECKLIST IS TO REMAIN IN OWNER’S MANUAL
It is the responsibility of the dealer to complete the procedures listed below, then
review this checklist with the customer upon the delivery or the sale of this implement.
DEALER PREPARATION CHECK LIST
Frontier 10 Series Rotary Cutter
2 Introduction