Filter
Top Products
Installing - 12
INSTALLING
4. Move belt guide (E) and roll upper V-belt around tractor
engine drive pulley (F).
Attach Lower Mounting Frame to Tractor
1. Move snowblower lift bar forward to the lowered
position.
2. Slide snowblower lift handle under rear of lower
mounting frame and lift up to raise front mounting brackets
into clevises of mounting angles.
3. Align the hole in the front mounting brackets (A) with
hole in mounting angle clevis (B) and secure with clevis pin
andhaircotterpins(C).
4. Remove the lift handle from under the snowblower.
Set Lower V-Belt Tension
Pull tensioning chain (A) to tighten lower V-belt and secure
with hair cotter pin (B).
Install Clutch Link Rod
1. Place the tractor attachment lever in the disengaged
(OFF) position.
2. Move idler arm (A) to the left side of the snowblower
frame and hold against the stop.
3. Adjust the length of the clutch link rod (B) until the
mounting anchor (C) can be assembled into the clutch bell
crank.
4. Attach clutch rod link with hair cotter pin (D).
E
F
A
B
C
A
B
B
C
D
A