Operating - 26
OPERATING
Using Storage Accessories
MX10524
A - Glove Storage Pocket
• Use the storage pocket (A) for small items such as
gloves.
MX10528
• On Models Without Cruise Control: Use the storage
retainer (B) to hold an electronic device such as garage
door opener.
Using Weights
NOTE: See your Authorized Service Center for
recommended weights.
• Install front weights for added stability and steering
control when you use equipment such as the rear-mounted
grass bagger.
• Install rear weights when using the snow blade or
snowblower.
• Remove weights when not required.
Using Tire Chains
Tire chains are recommended for use with snowblower and
snow blade.
See your Authorized Service Center for tire chains.
Mowing Tips
The following recommendations will produce the best lawn
cut quality and appearance:
• Keep mower blades sharp. Dull blades will tear grass;
tips of grass will then turn brown.
• Cutting grass too short may kill grass and let weeds
grow easily.
• Adjust cutting height to remove only 1/3 of the grass at a
time.
• Mow grass often. Short grass clippings will decay
quickly.
• Mow with engine at full throttle.
• Adjust travel speed to match mowing conditions:
• Travel at slow speed when you mow thick, tall grass,
make sharp turns, trim around objects, or when
mulching.
• Travel at moderate speed when you mow thin grass.
• Use a different mowing pattern each time you mow.
Overlap mowing paths 50 to 100 mm (2 to 4 in).
• Drive over ridges and through shallow ditches straight-
on, not at an angle.
• A thick layer of mulched leaves can prevent sunlight
from getting to grass and smother it. Taller grass heights
allow mulched leaves to dispense easier in lawn. Mulch
leaves several times if needed.
• Use a thatcher in late spring or summer to pull up dead
grass and aerate ground.
c CAUTION: Avoid injury! The machine may
become unstable when operating on slopes
and/or with some attachments.
Use front weights or rear weights to improve
stability when operating on slopes or using
attachments.
Remove weights when not required.
A
B