Filter
Top Products
CAUTION: Stand clear of bands when cutting as they could be under sufficient
tension to cause them to fly loose. Take care in removing bands and wire, they
often have extremely sharp edges and cut very easily.
As mentioned above, all our grooming mowers may be either tractor front or rear
mounted. Changing our mowers from front mount to rear, or vice versa, can be easily
done at our authorized dealerships. This is accomplished by simply turning the three
point hitch and the gearbox 180 degrees (see fig. 3 & 4).
3.03 - Cutting Height Adjustment
WARNING: Keep hands and feet away from moving blades.
Be sure tractor engine is off, parking brake is locked, and key is removed before
making any adjustments.
Never rely on the tractor lift system. Install blocks or stands under the mower
deck to prevent it from falling.
The cutting height is the distance from the blades to the ground. The cutting height is
adjusted by moving the spacers on the wheel yokes. Placing spacers between the
wheel arm and the wheel yoke raises the cutting height by the size of the spacer.
Removing the spacers lowers it by the same height (see fig. 5).
Be sure all wheel arms are adjusted equally. This is the only way to ensure a completely
uniform cut.
OPERATION 13 FRONTIER
G
ROOMING MOWERS OPERATOR’S MANUAL
Fig. 5
The cutting height is
adjusted by moving
the height adjustment
spacers on the wheel
yokes above or below
the wheel arm.