Filter
Top Products
7. Lift the front of the central plate and remove old belts.
8. Replace new belts (see fig. 15). Loop the first belt over the left spindle and around
the lower groove of the center spindle pulley and the lower groove of the gearbox
drive pulley. The second belt connects the upper grooves of the center spindle
pulley and the gearbox drive pulley with the right spindle pulley.
9. Lower central plate.
10.Replace front nuts. Tighten front and rear nuts holding down central plate.
11.Turn the adjustment bolt counter clockwise until the proper belt tension is reached.
This will draw the gearbox support plate to the rear, thus tightening the belts.
12.Tighten the two blocking nuts on the adjustment bolt.
13.Retighten the four nuts holding the gearbox support to the central plate and replace
the belt shields.
4.06 - Driveline
DANGER: Only use the original driveline supplied with this mower and always
with the safety shielding. Carefully read and file away the driveline operator’s
manual supplied by the manufacturer. The following does not substitute the
information found in the driveline manual.
IMPORTANT: Always check driveline length during initial setup and when connecting to
a different tractor.
In the collapsed position the driveline should be approximately 2” from bottoming out to
prevent possible damage to the tractor or implement. When the driveline is in the
maximum extended position, the ideal minimum overlap of the two halves should be
approximately 6” (see fig. 16).
M
AINTENANCE
29 FRONTIER
G
ROOMING
M
OWER
O
PERATOR
’
S
M
ANUAL
Fig. 15
1. drive pulley
2. central pulley
3. lateral pulleys
4. right belt
5. left belt
1
2
4
3
3
5