Filter
Top Products
36 Dealer Check Lists
5WPMAN0183 (Rev. 4/25/2008)
DEALER CHECK LISTS
PRE-DELIVERY CHECK LIST
(DEALER’S RESPONSIBILITY)
Inspect the equipment thoroughly after assembly to
ensure it is set up properly before delivering it to the
customer.
The following check lists are a reminder of points to
inspect. Check off each item as it is found satisfactory
or after proper adjustment is made.
___ Check that all safety decals are installed and in
good condition. Replace if damaged.
___ Check that shields and guards are properly
installed and in good condition. Replace if dam-
aged.
___ Check all bolts to be sure they are properly
torqued.
___ Check that all cotter pins and safety pins are
properly installed. Replace if damaged.
___ Check that blades have been properly installed.
___ Check mower attitude and belt alignment
___ Check and grease all lubrication points as iden-
tified in lubrication information on page 20.
___ Check the level of gearbox fluids before deliv-
ery. Service, if required, as specified in the lubri-
cation information on page 20.
DELIVERY CHECK LIST
(DEALER’S RESPONSIBILITY)
___ Show customer how to make adjustments and
select proper PTO speed.
___ Show customer how to make sure driveline is
properly installed and that spring-activated lock-
ing pin or collar slides freely and is seated in
groove on tractor PTO shaft.
___ Show customer how to determine the turning
limits of the CV PTO driveline.
___ Show customer the safe, proper procedures to
be used when mounting, dismounting, and stor-
ing equipment.
___ Make customer aware of optional equipment
available so that customer can make proper
choices as required.
___ Instruct customer how to lubricate and explain
importance of lubrication.
___ Point out the safety decals. Explain their mean-
ing and the need to keep them in place and in
good condition. Emphasize the increased safety
hazards when instructions are not followed.
___ Present Operator's Manual and request that
customer and all operators read it before oper-
ating equipment. Point out the manual safety
rules, explain their meanings and emphasize
the increased safety hazards that exist when
safety rules are not followed.
___ Explain to customer the potential crushing haz-
ards of going underneath raised equipment.
Instruct that before going underneath to discon-
nect the driveline, securely block up all corners
with jackstands and to follow all instructions in
the “Blocking Method” on page 19 of the opera-
tors manual. Explain that blocking up prevents
equipment dropping from hydraulic leak down,
hydraulic system failures or mechanical compo-
nent failures.
___ Point out all guards and shields. Explain their
importance and the safety hazards that exist
when not kept in place and in good condition.