Filter
Top Products
down
Three-Point Hitch 210LE
Bore Stroke Rod
Lift (1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3.00 in. (76.2 mm) 8.00 in. (203.0 mm) 2.00 in. (50.8 mm)
Pitch (1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.50 in.(63.5 mm) 8.50 in. (215.9 mm) 1.25 in. (31.8 mm)
Tilt (1). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3.00 in. (76.2 mm) 4.75 in. (120.7 mm) 2.00 in.(50.8 mm)
Tires
Rear Front
With mechanical-front-wheel-drive. . . . . . . . . . . . . . . . . . . 16.9-24, 8 PR R4 12-16.5, 8 PR NHS
Category II Three-Point Hitch
Type. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . heavy duty,integral to vehicle mainframe,with individual lever control of the lift, tilt,pitch,and auxiliary functions and with down force and float on the lift circuit
Static lift at lower link,ends horizontal. . . . . . . . . . . . . . . . 6,870 lbf (30.57 kN)
Static lift 24 in. (610 mm) behind lift points . . . . . . . . . . . . 3,790 lbf (16.85 kN)
Controlled hydraulic flow rate, maximum . . . . . . . . . . . . . . 10 gpm (37.9 L/min.)
SAE J/ISO 6016.3.2.1 Operating Weights
Base tractor with full fuel tank and 165-lb.(75 kg)
operator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9,130 lb. (4141 kg)
Hitch weight / drawbar. . . . . . . . . . . . . . . . . . . . . . . . . . . . 535 lb. (243 kg)
Wheel weights . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1,100 lb. (499 kg)
1.00-cu.-yd.(0.76 m
3
) bucket. . . . . . . . . . . . . . . . . . . . . . . 740 lb. (336 kg)
1.12-cu.-yd.(0.86 m
3
) bucket. . . . . . . . . . . . . . . . . . . . . . . 940 lb. (426 kg)
1.25-cu.-yd.(0.96 m
3
) multipurpose bucket. . . . . . . . . . . . 1,640 lb.(744 kg)
88-in.-wide Cameco-brand box blade . . . . . . . . . . . . . . . . 1,650 lb.(748 kg)
84-in.-wide Cameco-brand box blade . . . . . . . . . . . . . . . . 1,620 lb.(735 kg)
Maximum allowable operating weight . . . . . . . . . . . . . . . . 16,000 lb. (7257 kg)
Loader Buckets
Width Heaped Capacity Weight
Heavy-duty long lip. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 86 in. (2180 mm) 1.00 cu. yd. (0.76 m
3
) 710 lb.(322 kg)
86 in.(2180 mm) 1.12 cu.yd. (0.86 m
3
) 940 lb.(426 kg)
Multipurpose . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 86 in.(2180 mm) 1.12 cu. yd. (0.86 m
3
)1,450 lb.(658 kg)
Loader Performance
with 1.00-cu.yd. (0.76 m
3
) with 1.12-cu.yd. (0.86 m
3
) with 1.25-cu.yd. (0.96 m
3
)
Heavy-Duty Long Lip Bucket Heavy-Duty Long Lip Bucket Multipurpose Bucket
Operator control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . single lever single lever single lever
Breakout force . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7,900 lbf (35.14 kN) 7,750 lbf (34.47 kN) 6,900 lbf (30.69 kN)
Lifting capacity, full height . . . . . . . . . . . . . . . . . . . . . . . . . 5,280 lb.(2395 kg) 5,100 lb. (2313 kg) 4,600 lb. (2086 kg)
Height to bucket hinge pin, maximum . . . . . . . . . . . . . . . . 11 ft.4.7 in. (3.47 m) 11 ft. 4.7 in.(3.47 m) 11 ft. 4.7 in. (3.47 m)
Dump clearance, bucket at 45 degrees . . . . . . . . . . . . . . . 8 ft. 4.6 in.(2.56 m) 8 ft.4.4 in.(2.55 m) 8 ft.0.5 in. (2.45 m)
Reach at full height, bucket at 41.6 degrees . . . . . . . . . . . 34.4 in.(875 mm) 33.8 in. (858 mm) 35.4 in.(899 mm)
Rollback angle at ground level . . . . . . . . . . . . . . . . . . . . . . 44 degrees 44 degrees 44 degrees
Digging depth below ground, bucket level . . . . . . . . . . . . . 9.6 in. (245 mm) 10.2 in. (259 mm) 11.8 in. (300 mm)
Raising time to full height. . . . . . . . . . . . . . . . . . . . . . . . . . 5.2 sec. 5.2 sec. 5.2 sec.
Bucket dump time . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.5 sec. 1.5 sec. 1.5 sec.
Bucket lowering time (power down) . . . . . . . . . . . . . . . . . . 2.4 sec. 2.4 sec. 2.4 sec.
Tractor Loader Dimensions
A
At 45-degree dump angle. . . . . . . . . . . . . . . . . . . . 10 ft. 10.9 in.(3.33 m)
At full height. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 ft.4.7 in.(3.47 m)
B At 45-degree dump angle. . . . . . . . . . . . . . . . . . . . 8 ft. 4.6 in.(2.56 m)
At full height. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 ft.9.7 in.(2.69 m)
C Bucket pin 11 in. (280 mm) off ground . . . . . . . . . . 44 degrees
D At full height. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 41.6 degrees
E At 45-degree dump angle. . . . . . . . . . . . . . . . . . . . 37.0 in. (940 mm)
At full height. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34.4 in.(874 mm)
F Lower link horizontal. . . . . . . . . . . . . . . . . . . . . . . . 45.0 in. (1143 mm)
G Bucket level . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9.6 in. (244 mm)
H Bucket level on ground. . . . . . . . . . . . . . . . . . . . . . 78.1 in. (1984 mm)
Bucket rolled back,pin 11 in.(280 mm) off ground . . . 76.6 in. (1946 mm)
I Wheelbase . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 83.3 in. (2116 mm)
J Transport height . . . . . . . . . . . . . . . . . . . . . . . . . . . 97.6 in. (2479 mm)
K Bucket level on ground . . . . . . . . . . . . . . . . . . . . . . 17 ft. 2 in. (5.2 m)
L Lower link pin center . . . . . . . . . . . . . . . . . . . . . . . 1.6 in. (40 mm)
M Static loaded radius . . . . . . . . . . . . . . . . . . . . . . . . 23.0 in. (584 mm)
N Ground clearance
Under MFWD axle. . . . . . . . . . . . . . . . . . . . . . . . . . 11.3 in. (287 mm)
Under transmission. . . . . . . . . . . . . . . . . . . . . . . . . 12.3 in.(312 mm)
Width over rear tires. . . . . . . . . . . . . . . . . . . . . . . . 84.0 in. (2134 mm)
Three-Point Hitch Dimensions
a
Height of hole for top link . . . . . . . . . . . . . . . . . . . . 30.8 in. (783 mm)
b Height of rear axle center . . . . . . . . . . . . . . . . . . . . 23.0 in. (584 mm)
c Top link hole distance from rear axle center . . . . . . 17.7 in.(450 mm)
d Height of lower link point . . . . . . . . . . . . . . . . . . . . 18.3 in.(465 mm)
e Lower link point distance from rear axle center . . . 14.0 in.(356 mm)
f Pitch cylinder (top link)
Retracted . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22.5 in. (572 mm) min.
Extended. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31.0 in. (788 mm) max.
g Lower link length . . . . . . . . . . . . . . . . . . . . . . . . . . 29.5 in. (749 mm)
h Maximum height of lower link. . . . . . . . . . . . . . . . . 28.1 in. (714 mm)
i Minimum height of lower link . . . . . . . . . . . . . . . . . 7.7 in. (196 mm)
j Height of drawbar. . . . . . . . . . . . . . . . . . . . . . . . . . 12.8 in. (325 mm)
k Hitch pin from rear axle center . . . . . . . . . . . . . . . . 33.2 in.(843 mm)
B
G
C
M
D
E
K
I
N
F
H
L
A
J
b
a
j
d
e
k
g
i
h
f
c
DKA210LE Page 11
Vertis QCA
1300 19th Street, Suite 200
East Moline, IL 61244
Cyan
Magenta
Yellow Black
DKA210LE_SPECS 9/19/05 11:16 AM Page 11