Filter
Top Products
www.JohnDeere.com
Key: ● Standard ▲ Optional or special See your John Deere dealer for further information.
Additional equipment
DKAX160180G Litho in U.S.A. (12-04)
Net engine power is with standard equipment including air cleaner, exhaust system, alternator, and cooling fan, at test conditions specified per ISO 9249.
No derating is required up to 3050-m (10,000 ft.) altitude. Specifications and design subject to change without notice. Wherever applicable, specifications
are in accordance with SAE standards. Except where otherwise noted, these specifications are based on units with 700-mm (28 in.) triple semi-grouser shoes,
full fuel tanks, and 79-kg (175 lb.) operators; a 160G LC unit with 914-mm (36 in.), 0.62-m
3
(0.81 cu. yd.), 623-kg (1,373 lb.) general-purpose bucket; 3.10-m
(10 ft. 2 in.) arm; 3210-kg (7,077 lb.) counterweight; and a 180G LC unit with 1067-mm (42 in.), 0.83-m
3
(1.09 cu. yd.), 785-kg (1,731 lb.) general-purpose bucket;
3.21-m (10 ft. 6 in.) arm; and 3910-kg (8,620 lb.) counterweight.
160G
LC
180G
LC
Engine
● ●
Auto-idle system
● ●
Automatic belt-tension device
● ●
Batteries (2 – 12 volt)
● ●
Coolant recovery tank
● ●
© ual-element dry-type air filter
● ●
Electronic engine control
● ●
Enclosed fan guard (conforms to SAE
J1308)
● ●
Engine coolant to –37 deg. C (–34 deg. F)
● ●
Fuel filter with water separator
● ●
Full-flow oil filter
● ●
Turbocharger with charge air cooler
● ●
Cool-on-demand hydraulic-driven fan
● ●
500-hour engine-oil-change interval
● ●
70% (35 deg.) off-level capability
● ●
Engine-oil-sampling valve
● ●
Programmable auto shutdown
▲ ▲
Chrome exhaust stack
▲ ▲
Severe-duty fuel filter
▲ ▲
Hydraulic fan reverser
▲ ▲
Engine coolant heater
Hydraulic System
● ●
Reduced-drift valve for boom down,
arm in
● ●
Auxiliary hydraulic valve section
● ●
Spring-applied, hydraulically released
automatic swing brake
● ●
Auxiliary hydraulic-flow adjustments
through monitor
● ●
Auto power lift
● ●
5,000-hour hydraulic-oil-change interval
● ●
Hydraulic-oil-sampling valve
▲ ▲
Auxiliary hydraulic lines
▲ ▲
Auxiliary pilot and electric controls
▲ ▲
Hydraulic filter restriction indicator kit
▲ ▲
Load-lowering control device
▲ ▲
Single-pedal propel control
▲ ▲
Control pattern-change valve
Undercarriage
● ●
Planetary drive with axial piston motors
● ●
Propel motor shields
● ●
Spring-applied, hydraulically released
automatic propel brake
● ●
Track guides, front idler and center
● ●
2-speed propel with automatic shift
● ●
Upper carrier rollers (2)
● ●
Sealed and lubricated track chain
▲ ▲
Triple semi-grouser shoes, 600 mm (24 in.)
▲ ▲
Triple semi-grouser shoes, 700 mm (28 in.)
▲
Triple semi-grouser shoes, 800 mm (32 in.)
160G
LC
180G
LC
Upperstructure
● ●
Right-hand, left-hand, and counter-
weight mirrors
● ●
Vandal locks with ignition key: Cab door /
Service doors / Toolbox
● ●
Debris-screening side panel
● ●
Remote-mounted engine oil and fuel
filters
Front Attachments
● ●
Centralized lubrication system
● ●
Dirt seals on all bucket pins
● ●
Less boom and arm
● ●
Oil-impregnated bushings
● ●
Reinforced resin thrust plates
● ●
Tungsten carbide thermal coating on
arm-to-bucket joint
▲
Arm, 2.60 m (8 ft. 6 in.)
▲
Arm, 2.71 m (8 ft. 10 in.)
▲
Arm, 3.10 m (10 ft. 2 in.)
▲
Arm, 3.21 m (10 ft. 6 in.)
▲ ▲
Attachment quick-couplers
▲ ▲
Boom cylinder with plumbing to main-
frame less boom and arm
▲ ▲
Buckets: Ditching / Heavy duty / Heavy-
duty high capacity / Side cutters and teeth
▲ ▲
Material clamps
Operator’s Station
● ●
Meets ISO 12117-2 for ROPS
● ●
Adjustable independent-control positions
(levers-to-seat, seat-to-pedals)
● ●
AM/FM radio
● ●
Auto climate control/air conditioner/
heater/pressurizer
● ●
Built-in Operator’s Manual storage
compartment and manual
● ●
Cell-phone power outlet, 12 volt, 60 watt,
5 amp
● ●
Coat hook
● ●
Deluxe suspension cloth seat with
100-mm (4 in.) adjustable armrests
● ●
Floor mat
● ●
Front windshield wiper with intermittent
speeds
● ●
Gauges (illuminated): Engine coolant /
Fuel
● ●
Horn, electric
● ●
Hour meter, electric
● ●
Hydraulic shutoff lever, all controls
● ●
Hydraulic warm-up control
● ●
Interior light
● ●
Large cup holder
160G
LC
180G
LC
Operator’s Station
(continued)
● ●
Machine Information Center (MIC)
● ●
Mode selectors (illuminated): Power
modes (3) / Travel modes (2 with auto-
matic shift) / Work mode (1)
● ●
Multifunction, color LCD monitor with:
Diagnostic capability / Multiple-language
capabilities / Maintenance tracking /
Clock / System monitoring with alarm
features: Auto-idle indicator, engine air
cleaner restriction indicator light, engine
check, engine coolant temperature indi-
cator light with audible alarm, engine
oil pressure indicator light with audible
alarm, low-alternator-charge indicator
light, low-fuel indicator light, fault code
alert indicator, fuel-rate display, wiper-
mode indicator, work-lights-on indicator,
and work-mode indicator
● ●
Motion alarm with cancel switch (con-
forms to SAE J994)
● ●
Power-boost switch on right console lever
● ●
Auxiliary hydraulic control switches in
right console lever
● ●
SAE 2-lever control pattern
● ●
Seat belt, 51 mm (2 in.), retractable
● ●
Tinted glass
● ●
Transparent tinted overhead hatch
● ●
Hot/cold beverage compartment
▲ ▲
Air-suspension heated seat
▲ ▲
24- to 12-volt D.C. radio convertors,
10 amp
▲ ▲
Hydraulic oil filter restriction indicator
light
▲ ▲
Protection screens for cab front, rear,
and side
▲ ▲
Seat belt, 76 mm (3 in.), non-retractable
▲ ▲
Window vandal-protection covers
Electrical
● ●
100-amp alternator
● ●
Blade-type multi-fused circuits
● ●
Positive-terminal battery covers
● ●
JDLink™ wireless communication system
(available in specific countries; see your
dealer for details)
▲ ▲
Rearview camera
▲ ▲
Cab extension wiring harness
Lights
● ●
Work lights: Halogen / One mounted on
boom / One mounted on frame
▲ ▲
2 lights mounted on cab / One mounted
on right side of boom