Filter
Top Products
TOWERS AND DOOR INSTALLATION
APPLY SEALANT ALONG BASE AND
SIDE OF WALL POST AND GLASS AND
WALL POST (BOTH SIDES)
APPLY SEALANT
ALONG BASE
OF FIXED GLASS
(BOTH SIDES)
APPLY SEALANT ALONG SIDE OF JAMB
AND DOOR POST AND JAMB AND GLASS
(BOTH TOWERS)
APPLY SEALANT ALL AROUND
TOWER BASES (ALL 3 BASES)
(RAIL NOT SHOWN)
STEP 19
Seal all around all bases of towers with sealant. Also seal the inside of both wall posts, jambs, door posts and bottom
of both glass side panels on the inside only.
CLEAN UP AFTER TOWERS AND DOOR INSTALLATION
To avoid dulling and scratching the tower surfaces and support rails never use abrasive cleaners. Use a mild liquid
detergent and warm water clean soiled surfaces. Use a mild glass cleaner to clean glass panels and doors.
Paint, tar, or other difficult stains can be removed with normal glass and finish cleaners. Use caution when applying
these products to coated metal surfaces. Test in an inconspicuous place before using. Do not use abrasives, alcohol,
acetone, ammonia or other solvents on any tower component.
Scratches to towers and metal components may not buff or polish out requiring surface refinishing or replacement.
Consult your Jacuzzi Whirlpool Bath
©
dealer or visit our website at: http://jacuzzi.com/ for a list of authorized finish
contractors.
15
Jacuzzi Whirlpool Bath
©
BY82000 03/05
STEP 20
Remove tape over drain and any other masking or protective covers. Proceed with clean up.