Filter
Top Products
ENGLISH
24
Jacuzzi Whirlpool Bath K339000X 3/06
Suction/Intake Cover/Strainer Maintenance
Clean the suction/intake cover/strainer of hair and debris
when necessary. To do this, remove the center screw and
detach the square cover. Clean the cover by backflushing
debris from the holes. Replace the suction/intake cover im-
mediately after cleaning. When reinstalling, orient the cover/
strainer with the small notch at the bottom. The gasket must
be inserted into the groove of the cover/strainer before rein-
stalling onto the suction fitting.
CAUTION: Keep hair a minimum of 6 inches (15,2 cm)
away from the suction/intake fitting at all times when the
whirlpool system is operating. Hair longer than shoulder
length should be secured close to the head, or a bathing
cap should be worn. Do not operate the whirlpool sys-
tem with the suction/intake cover removed! It is a safety
device and must always be in place on the suction fitting
to minimize the potential hazard of hair and/or body en-
trapment.
NOTCH
GASKET
COVER STRAINER
SCREW
SUCTION
FITTING
SUCTION COVER/STRAINER ASSEMBLY
Lighting (Chromotherapy lighting)
Your unit has Chromotherapy (LED) lighting. If the lights
fail to function contact your Jacuzzi Whirlpool Bath dealer.
There are no customer serviceable components on the Chro-
motherapy lighting.
Replacement fixtures are available from your Jacuzzi
Whirlpool Bath dealer.
LIGHT BEZEL
SHELL
LOCKING NUT
LED LIGHT ASSEMBLY
MAINTENANCE INSTRUCTIONS
Lighting (optional Illumatherapy
TM
lighting)
If your unit has Illumatherapy (fiberoptic) lighting and the
lights fail to function contact your Jacuzzi Whirlpool Bath
dealer. There are no customer serviceable components on
the Illumatherapy lighting.
Replacement fixtures are available from your Jacuzzi
Whirlpool Bath dealer.
LIGHT BEZEL
SHELL
LOCKING NUT
JET WITH FIBEROPTIC LIGHTS
DIN BOX (MOUNTED
ONTO FIBERGLASS SHELL)
FIBEROPTIC CABLE
(ROUTED TO WHIRLPOOL
CONTROL BOX)
FIBEROPTIC CABLES
ROUTED FROM JET TO DIN BOX