Filter
Top Products
5
Equipment Set-Up
1.
5.
4.
3.
2.
Remove the plastic sheet covering the spa. Use care;
stepping into the spa with shoes will scratch the acrylic
surface.
Remove any packing materials from the spa.
Open the door panel.
Open the skimmer/filter door by the handle located in the
middle of the door and remove the skimmer basket.
Then insert the filter cartridge into the filter housing and
re-insert the strainer so that it fits in place over the filter
cartridge and close the skimmer/filter door.
Clean the interior of the spa of any remaining construc-
tion debris. Remove stubborn stains, paint, or tar with
turpentine, isopropyl alcohol or paint thinner. A mild
liquid dishwashing detergent on a damp cloth is fine for
cleaning off other dirt. Plaster can be removed by
scraping with a wooden edge; do not use a metal
scraper, wire brush, or other metal tools, as they will
damage the spa’s surface.
On initial start-up, it is advisable to purge and sanitize the
system as stated below. Carefully follow the procedure
described here to purge and sanitize your spa.
6.
Close the hose bibb and fill the spa with water to approx.
6 inches below the spa rim or to water line indicator mark
on the skimmer frame.
Set the heater thermostat for the maximum temperature.
Test the spa for proper operation. (Refer to "Operating
Instructions.")
Refer to Water Quality section of the "Operating Instruc-
tions." Test for water quality, then add treatment chemi-
cals to ensure proper levels.
8.
Select WHIRLPOOL on the function selector switch.
Add
1
/4 cup sodium dichlor (a fast dissolving granular
type of chlorine) to the water and let the whirlpool run for
15-20 minutes only.
Select OFF on the function select switch.
Unplug the line cord. Next, open the redwood skirt door.
Open the hose bibb and drain the spa completely.
10.
CAUTION: Leave the rigid cover off the spa during this
procedure. Do not use the spa during this procedure.
Drain the spa immediately afterward.
11.
9.
INSTALLATION
HIGH
TEMPERATURE
SAFETY RESET
SWITCH LOCATION
BONDING CABLE
TO GROUND
HOSE BIBB
(DRAIN VALVE)
GFCI CABLE
BOND BAR
SYSTEM CONTROL
MODULE
JUNCTION BOX
1 HP
WHIRPOOL/MOTOR
PUMP LOCATION
SPA RIM SERIAL NUMBR LOCATION
(ON SPA SHELL)
SERIAL FUNCTION SELECTOR
CONTROL PANEL
All Jacuzzi Whirlpool Bath spas are factory tested for proper op-
eration and water tight connections prior to shipping. If leaks or
other malfunctions are detected, immediately notify your Jacuzzi
Whirlpool Bath dealer or Authorized Service Agent, or call
Jacuzzi Whirlpool Bath, (510) 938-7411 for Warranty Service.
Remove the spa cover completely.
Close the hose bibb located on the suction tee plumb-
ing.
Fill the spa with water to its normal operating level,
which is to the water level indicator mark on the
skimmer/filter frame (6'' below the spa rim).