Filter
Top Products
www.irobot.com 23
Troubleshooting
(cont...)
Problem Likely Cause What to Do
Verro is not removing
attached dirt
and debris
The filter bag needs to
be cleaned
Flaps in the vacuum
intakes at bottom of
robot are blocked
The pump impeller is
fouled by dirt or debris
Jet tube is blocked
Clean the filter bag. (p. 13)
Check the flaps in the vacuum intakes.
(p. 20)
Clean the pump impeller. (p. 17)
Clean jet tube. (p. 19)
The floating power
cord is tangled
or kinked
The floating power cord
is twisted
Use Detangler to untwist the cord. (p. 16)
Verro gets stuck on
its floating power cord
The floating power cord
is twisted
Use Detangler to untwist the cord. (p. 16)
Verro will not start a
cleaning cycle
Reset required
Verro is not plugged
into the Power Supply
The Power Supply is not
plugged in
Turn Power Supply OFF and then back ON.
Press reset button.
Plug Verro into the Power Supply.
Plug the Power Supply into GFCI outlet only.