Invacare Model Hot Tub User Manual


 
5 OPERATING INSTRUCTIONS
Part No. 1167458
23 Invacare® TheraPure™ Recessed Whirlpool Tubs
8. Replace the impeller and impeller cap on each jet assembly.
9. Assemble each jet assembly to the jet casings.
Position the Sanijet® logo and RED indicator at the 11 o’clock position.
Insert the jet assembly into the receptacle in the tub and rotate the jet assembly clockwise until it locks into place.
Removing Soap Film and Hard Water Deposits
Use a commercially available cleaner such as Invacare Heavy Duty Cleaner. Remove the jet assemblies. Remove the impeller caps. Thoroughly spray the
exposed surfaces, including the jet casings. Use a long handled soft brush or similar product to wipe down all surfaces and allow the heavy duty cleaner to
remain in contact with the exposed surfaces for approximately ten minutes. Rinse off surfaces using the shower wand, adjusted to spray position.
ƽ
WARNING
Cross-threading the jet assembly onto the casing may
cause damage to the whirlpool motor. After installation,
ensure that the jet assembly is flush against the jet casing.