Filter
Top Products
SECTION 2—PARTS AND INSTALLATION
Part No 1118387 17 Side Entry Whirlpool Tub
Electrical and Plumbing Hook-up Locations on the Tub
NOTE:Forthisprocedure,refertoFIGURE 2.3onpage17.
NOTE:ForinstallationdetailsrefertoElectricalInstallationonpage 17andPlumbing
Installationonpage 20.
FIGURE 2.3 Electrical and Plumbing Hook-up Locations on the Tub
Electrical Installation
Ꮨ DANGER
When using electrical products, basic precautions should always be followed,
including the following:
RISK OF ELECTRIC SHOCK. Connect the bathtub only to a circuit protected by a
ground-fault circuit-interrupter (GFCI). Use a 15 AMP GFCI breaker only.
The National Electric Code requires the use of a ground fault circuit interrupter on
all therapeutic pools and tubs (hydrotherapeutic tanks). Failure to follow this
requirement could result in serious or fatal injury.
Grounding is required. The unit should be installed by a qualified service
representative and grounded.
ELECTRICAL SHOCK HAZARD. All disassembly and maintenance of the tub
MUST be done by a qualified technician, certified electrician or plumber. Be certain
all electrical work is in compliance with local electrical codes.
All electrical connections are to be water resistant.
Disconnect electrical supply or turn off the circuit breaker before performing any
maintenance to the tub.
All electrical conduit, fittings and wire to unit are to be supplied and installed by a
professional electrician in accordance with the National electrical code as a
minimum requirement, including the supply and installation of a Ground Fault
Circuit Interrupter (GFCI).
Before installing and connecting the tub, make certain that the electrical power
source is shut off to avoid electrical shock.
Electrical Line
Routing Hole
Cold Water Inlet
Hot Water Inlet
Model 3650Models 3600 and 3600XL
Electrical Line
Routing Hole
¾-inch Hot
and Cold
Water Inlets
2-inch Drain PVC Pipe