Filter
Top Products
8
SET-UP AND ASSEMBLY
Before beginning assembly, carefully read the
following information and instructions:
• Place all parts in a cleared area and remove the
packing materials from the spa shell; do not dis-
pose of the packing materials until assembly is
completed and the spa is in operation.
• Assembly requires two people.
• During assembly, make sure that all parts are ori-
ented as shown in the drawings.
• Read each assembly step before you begin.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
ASSEMBLY REQUIRES THE FOLLOWING
TOOLS (NOT INCLUDED):
• One (1) phillips screwdriver
• You may also need a small amount of soap
or wax.
1. Before beginning assembly, make sure that you
have read and understand the information on
the previous two pages.
To remove the access cover, insert fingers into the
finger holes and pull it away from the Spa Unit (15).
Be careful not to damage the spa shell as you
remove the cover.
2. Locate and check the positions of the two cut-off
valves. The cut-off valves may have been closed at
the factory during manufacturing. However, the cut-
off valves must be open when the spa is operated.
To open the valves, turn the handles and pull them
out to the open position. IMPORTANT: THE
MOTOR WILL BE DAMAGED IF IT IS OPERATED
WITH THE CUT-OFF VALVES CLOSED.
Next, close the valve knob on the drain hose.
Thread the cap onto the drain hose. Thread the
drain plug into the Pump Motor (13). Tighten the
pump fittings.
2
Cut-off Valve
Pump
Fittings
Cut-off
Valve
Drain Hose
Valve
Knob
Cap
13
Drain
Plug
1
Access
Cover
Spa
Shell
15