Filter
Top Products
14
ADJUSTING THE FILTER CYCLE
The spa filter cycle runs automatically to clean the
water in the spa. However, the number of times that
the filter cycle needs to run depends on how often the
spa is used. If the spa is used regularly by several
people, the water will need to be filtered more often
than if it is used only occasionally by a few. The num-
ber of daily cycles, as well as the length of the cycle,
can be adjusted.
The pump can run one to three filter cycles daily. To
change the number of cycles, press the pump and up
buttons at the same time (refer to the console dia-
gram on page 13). The number of cycles will appear
in the temperature display. Press the up and down
buttons to select the desired number of cycles.
Each cycle can run for 60, 120, or 180 minutes. To
change the length of the cycle, press the light and up
buttons at the same time. The length of the cycle will
appear in the temperature display. Press the up and
down buttons to select the desired cycle length.
Note: The pump or the light may turn on while you are
adjusting the filter cycle. If this happens, you can turn
the pump or the light off once you have finished the
adjustment procedure.
SECURING THE SPA COVER
To secure the spa, snap the latches on the spa cover
into the buckles on the side panels.
To lock the buckles,
insert the key and turn
it clockwise 1/4 turn.
To unlock the buckles,
insert the key and turn
it counterclockwise 1/4
turn. Always keep the
buckles locked when
the spa is not in use.
Keep the keys in a
safe place, out of the reach of children.
ATTACHING THE RED AND BLUE LIGHT COVERS
The spa includes red
and blue light covers
for the spa light. To
attach one of the light
covers, hold the cover
over the light and
press the cover into
place.
Key
Latch
Buckle
Light
Cover
Light