Filter
Top Products
LUBRICATION GUIDE
Once a Year or After Every 100 Hours of Operation
8. Gear reduction drive
Check the oil level and add I H Hy- Tran@ Fluid if necessary.
Oil level should be no more than 5-inches from the bottom of theplug.
9. Hydrostatic drive
Check the oil level and add I H Hy- Tran Flu id if necessary.
NOTE: When cold 2-inches from top, when hot 3/4-inches from
top.
NOTE: If fluid is used which does not meet requirements of I H
8-6 Specification, International Harvester Company will not be
responsible for substandard performance of the transaxle. Failures
due to use of improper fluid are not covered by warranty. FOR
MAXIMUM PROTECTION USE IH HY-TRAN@ FLUID'
10. Steering wheel bushings (2)
Apply two or three drops of light oil and rotate the steering wheel
to distribute the oil.
Mower pulleys (2)
(threaded shafts)
(See page 19)
Lubricate the entire length of the threaded shafts in the hub of the
pulleys, the outer surface of the hub and the brake insert with I H
251 H EP grease or equivalent No.2 multi-purpose lithium grease.
22