Image IMSG63120, IMSB63120 Hot Tub User Manual


 
17
b. A clamp or seal inside the pump compartment
may be loose. Check inside the pump compart-
ment for excess water and watch the pump unit
while it is operating to see if water drips from
any of the plumbing. If you can identify the
location of the leak inside the spa jet unit, tight-
en the clamp or replace the damaged seal.
10. SYMPTOM: THE SPA JET UNIT CONTINUES
TO RUN AFTER IT HAS BEEN SHUT OFF
a. To turn the main jets off, press the pump button
once. NOTE: If the actual spa water tempera-
ture is below the set temperature, or if the spa
is running a filter cycle, the heater pump/motor
will not shut off.
11. SYMPTOM: NO AIR FLOWS THROUGH THE
ADJUSTABLE HYDROTHERAPY JETS WHEN
THE AIR CONTROL IS TURNED COUNTER-
CLOCKWISE
a. The eighteen adjustable hydrotherapy jets can
be closed and opened by turning the jet faces. If
no air flows through the hydrotherapy jets when
the air control is turned counterclockwise, turn
the jet faces counter clockwise.
12. SYMPTOM: THE CONSOLE DISPLAYS THE
WORDS “COOL” OR “ICE”
a. This is a normal function of the spa; no action
is necessary. The word “COOL” will appear in
the display if the temperature of the water is
more than 20°F cooler than the set tempera-
ture. If this happens, the heater will automati-
cally activate to warm the water. The word
“ICE” will appear if the temperature drops
below 40°F. If this happens, the pump will auto-
matically circulate the water and warm the
plumbing.
13. SYMPTOM: THE CONSOLE DISPLAYS ONE OF
THE FOLLOWING MESSAGES: “OH,” “5n1,”
“5n3,” “FLO,” “Pd,” “O3,” “PH50,” “PH90,” or
“ILOC”
a. If the console displays one of the messages
listed above, or if the console does not function
properly, contact our customer service depart-
ment.