Filter
Top Products
7
CHOOSING A LOCATION FOR THE RENEW 207
There are many factors to consider when choosing a location to set up the RENEW 207. These factors vary
depending on whether you plan to use the spa inside or outside. We have listed several factors you may wish to
consider as you decide where you want to set up the spa.
If you set up the RENEW 207 inside:
1. The RENEW 207 will increase the level of humidi-
ty in your home. The location you choose should
be well ventilated. You may need to install a venti-
lation fan or use a dehumidifier.
2. The location must be close to an electrical outlet.
Do not use an extension cord with the RENEW
207.
3. The RENEW 207 should be close to a source of
water.
4. Do not use the RENEW 207 on carpet or other
material that may be damaged by moisture. We
recommend that you place the spa on a water-
and stain-resistant, non-slip surface with a floor
drain for any water that may splash from the spa.
5. Be sure that the location you choose is stable. It
must be able to support the weight of the RENEW
207 when it is filled with water, plus the weight of
the occupants. The spa weighs approximately
1,500 pounds when filled with water.
6. Do not use the RENEW 207 above a finished liv-
ing area, due to the risk of water damage.
7. Be sure that there is room around the RENEW
207 to permit servicing of the unit. The dimensions
of the spa are: 3’ 7” W x 7’ 6” L x 2’ 5” H. You
should allow for this size when choosing the loca-
tion.
8. The RENEW 207 is not designed for in-floor
installation. However, it is compatible with a deck
system that is built flush with the top of the spa,
provided you leave access to the motor for ser-
vice.
9. Be sure to note any other considerations, such as
aesthetics or privacy concerns, that may affect the
safety or enjoyment of using the RENEW 207.
If you set up the RENEW 207 outside:
1. Check your local building codes concerning the
use of outdoor spas.
2. The location must be close to an electrical outlet.
Do not use an extension cord with the RENEW
207.
3. The RENEW 207 should be close to a source of
water.
4. We recommend that you place the RENEW 207
on a water- and stain-resistant, non-slip surface.
Do not use the spa on rough or sharp surfaces
such as gravel or wood chips.
5. Be sure that the location you choose is stable. It
must be able to support the weight of the RENEW
207 when it is filled with water, plus the weight of
the occupants. The spa weighs approximately
1,500 pounds when filled with water.
6. Consider environmental factors such as rain, wind,
shade, sunlight, and so forth.
7. You should be able to monitor the use of the
RENEW 207 from your home to prevent unautho-
rized use by children. You may want to enclose
the spa with a fence and self-latching gate to pre-
vent unauthorized use.
8. Be sure that there is room around the RENEW
207 to permit servicing of the spa. The dimensions
of the spa are: 3’ 7” W x 7’ 6” L x 2’ 5” H. You
should allow for this size when choosing the loca-
tion.
9. The RENEW 207 is not designed for in-ground
installation. However, it is compatible with a deck
system that is built flush with the top of the spa,
provided you leave access to the motor for ser-
vice.
10. Be sure to note any other considerations, such as
aesthetics or privacy concerns, that may affect the
safety or enjoyment of using the RENEW 207.