Filter
Top Products
15
To drain the RENEW 207, follow these steps:
1. Set the temperature control on the console to the
lowest setting.
2. Unplug the power cord.
3. Remove the access cover from the spa.
4. Remove the drainage hose from the clip and
attach a garden hose to the valve on the
drainage hose.
5. Open the valve by turning the knob counterclock-
wise. The water will begin to drain.
6. When the spa is empty, close the valve and
remove the garden hose. Return the drainage
hose to the clip and re-attach the access cover.
7. Refill the spa and treat the water with chemicals
(see pages 8 and 14).
WINTER USE AND CARE
The RENEW 207 is designed for year-round use. If
you decide to store the spa for the winter, store it in a
warm, dry location. Follow the steps below to winterize
the spa.
1. Drain the spa (see DRAINING THE RENEW 207
on page 14).
2. Remove all remaining water from the spa shell.
Dry the spa shell with towels.
3. Set the air control on the console to the lowest
setting. Use a wet/dry vacuum to pull any remain-
ing water from the system. To do this, place the
vacuum nozzle over each thera-jet, starting with
the highest one and finishing with the lowest one.
4. Set the air control on the console to the highest
setting and repeat step 3.
5. Clean the spa shell (see page 13).
6. Clean the filter (see page 13).
7. Re-attach the access cover.
8. Re-attach the spa cover.
Knob
Valve
Drain Hose