Filter
Top Products
5-2 108548_1208
Torque values
WARNING: Particular attention must be given to
tightening the blade bolts. Failure to correctly torque
these may result in the loss of a blade, which can cause
serious damage or personal injury.
Torque values are given below:
For all other torques refer to the standard torque chart found
elsewhere in this manual.
For engine torque values, see engine owner’s manual.
Washing the mower
When washing the mower, do not use a power washer. This
will help prevent water intrusion and ensure component
performance. Wipe with a dry rag after washing and then wipe
the metal surface with a rag soaked with oil.
Clean the grass catcher with water and allow it to dry before
using.
Fuel system
DANGER: To avoid personal injury or property
damage, use extreme care in handling gasoline.
Gasoline is extremely flammable and the vapors
are explosive.
DANGER: Observe usual fuel handling precautions:
Do not smoke while refueling. Extinguish all ciga-
rettes, cigars, pipes and other sources of ignition.
Do not remove fuel cap or fill tank with engine run-
ning or while engine is hot. Clean up any gasoline
spills.
Allow engine to cool before storing machine inside a
building.
Keep fuel away from open flame or spark and store
machine away from open flame or spark or pilot light
such as on a water heater or other appliances.
Use extreme care when handling gasoline and other
fuels. They are extremely flammable and vapors are
explosive. A fire or explosion from gasoline can burn
you and others and can damage property.
Never refuel or drain the fuel from the machine
indoors.
Never attempt to start engine when there is a strong
odor of gasoline fumes present. Locate and correct
cause.
Store gasoline in an approved container and keep it
out of the reach of children. Never buy more than a
30 day supply of gasoline.
Always place gasoline containers on the ground away
from your vehicle before filling.
Do not fill gasoline containers inside a vehicle or on a
truck or trailer bed with interior carpets or plastic
truck bed liners. Always place gasoline containers on
the ground away from your vehicle before filling.
When practical, remove gas-powered equipment from
the truck or trailer and refuel the equipment with its
wheels on the ground. If this is not possible, then
refuel such equipment on the truck or trailer using a
portable container and not a gasoline dispenser noz-
zle. If a gasoline dispenser nozzle must be used, keep
the nozzle in contact with the rim of the fuel tank or
container opening at all times until fueling is com-
plete. Do not use a nozzle lock-open device.
Read and observe safety precautions elsewhere in this
manual.
WARNING: Gasoline is harmful or fatal if swal-
lowed.
Long-term exposure to vapors can cause serious
injury and illness.
Avoid prolonged breathing of vapors.
Keep face away from nozzle and gas tank or fuel con-
tainer opening.
Keep gas away from eyes and skin.
If fuel is spilled on clothing, change clothing immedi-
ately.
WARNING: Never overfill fuel tank. Replace gas
cap and tighten securely.
The fuel tank is located at the left rear of the engine. Fig. 5-1
Use regular unleaded gasoline with an octane rating of 87 or
higher.
IMPORTANT: Dispose of any unused gasoline properly
according to the law in each country.
IMPORTANT: Never use methanol, gasoline containing
methanol, or gasohol containing more than 10% ethanol because
the fuel system could be damaged. Do not mix oil with gaso-
line.
Engine oil and filter
IMPORTANT: Drain all of the gasoline from the fuel tank
before tilting the engine to drain the oil. Dispose of used engine
oil properly according to the law in each country.
IMPORTANT: All oil drips or spills must be cleaned off of
the exhaust system before operating the machine.
WARNING: Do not touch the engine and muffler as
they may be hot.
1. Remove the engine oil dipstick.
2. Remove the engine oil drain plug. Fig. 5-2
3. Tilt the mower onto it’s side to drain the oil. Fig. 5-2
4. Set the mower right side up and replace the oil drain plug.
Clean up any oil spill.
Ft-lbs. Nm
Blade spindle bolt top ...................26 - 33..........35 - 45
Fig. 5-1
Fuel tank