Filter
Top Products
English-32
OPERATION
c.
Tip the handles up or down until the
correct position is achieved. See "Cutting
height table", or reference the height
decal located on the muffler side of the
rear deck.
d.
Reinstall and tighten the outer three bolts
on each side. A tapered punch may be
needed to help align the holes.
e.
Retighten the center bolts on each side
and the two bolts on the front of the rear
deck.
5. Using the "Cutting height table", find the
correct number of spacers to be placed
under the caster swivel
6. Remove the lynch pin and washer from
the top of caster and reposition spacers
to the desired cutting height from the
table. See illustration "Caster height
adjustment"
8011-404
C
utting height table
8011-405
1
. Machinery bushing
2
. Caster swivel
3
. ½" "C" Spacers
C
aster height adjustment
IMPORTANT INFORMATION
To achieve the best quality cut, the blades
should be level with the ground or slightly
tipped forward.