Filter
Top Products
English – 23
Maintenance
5 Tighten the nuts after adjustment.
6 On completion of the adjustment the unit’s parallelism
should be re-checked.
7 Screw on the belt shield.
8 Fit the right-hand fender and the front hood.
Replacing the cutting unit belts
On these cutting units with collision-proof blades, the blades
are driven by one V-belt. Do as follows to change the V-belt:
1 Remove the cutting unit.
2 Open the lock for the track rod bolt.
3 Remove the bolt so the track rod is released in one end.
4 Unscrew the bolt holding the unit frame bracket.
5 Remove the lock and pass the unit frame out.
6 Remove the two bolts on the unit frame.
7 Remove the screws on the cutting cover. Lift the unit
frame and remove the cutting unit cover.
8 Loosen the spring that tensions the V-belt and pry off the
belt.
9 Simply reverse the procedure to fit the new belt.
!
WARNING! Wear gloves to protect your
hands when working with the blades. There
is a risk of crush injuries when working with
the belt.