Filter
Top Products
34 – English
ADD
FULL
ADD
FULL
MAINTENANCE
Changing the oil
The oil should be changed for the first time after 5
hours of running time. Thereafter it should be
changed every 25 hours of running time.
WARNING!
Engine oil can be very hot if it is
drained off directly after the
engine is stopped. Therefore allow
the engine to cool down first.
!
IMPORTANT INFORMATION
Used engine oil is hazardous to health and
environment and must in accordance with
the law not be poured out on the ground
or in the nature, and must be handed in to
a workshop or other designated station for
treatment. Avoid skin contact, wash with
soap and water in the event of spillage.
5. Fill up with oil to the FULL mark on the dip stick.
The oil is filled in the same hole for the dip stick.
Use engine oil SAE 30 or SAE 10W/30, class
CD-SF.
Use engine oil with min. API SF quality and SAE
30 or SAE 10W/30 viscosity grade. The oil
volume in the engine is 1.2 litres.
6. Run the engine warm and then check that there
is no leakage from the drain plug.
1. Place a receptacle under the engine’s drain
plug, located on the left-hand side of the engine.
2. Remove the dip stick and drain plug.
3. Let the oil run out into the receptacle.
4. Fit the drain plug and tighten.