Safety System
The machine is equipped with a safety system that prevents
starting or driving under the following conditions.
The engine can only be started when:
• The mower deck is disengaged.
• The steering controls are in the outer, locked neutral
position.
• The park brake is on.
IMPORTANT INFORMATION To be able to drive, the
driver must sit in the seat and release the park brake
before the steering controls can be moved into the neutral
position, otherwise the engine will stop.
Park Brake
Visually check that no damage is found on the lever, links, or
switch belonging to the park brake. Perform a standstill test
and check that there is sufficient braking action.
To adjust the park brake, contact the Husqvarna service
workshop.
IMPORTANT INFORMATION The machine must be
standing still when applying the park brake.
WARNING! Faulty adjustment will result in reduced
braking ability and can cause an accident.
Make daily inspections to ensure that the safety system works
by attempting to start the engine when one of the conditions is
not met. Change the conditions and try again.
If the machine starts when one of these conditions is not met,
turn the machine off and repair the safety system before using
the machine again.
Make sure the engine stops when the park brake is not
engaged and the operator leaves the seated position.
Check that the engine stops if the mower blades are engaged
and the driver temporarily moves off the driver's seat.
Tire Pressures
All tires should be at 15 psi / 103 kPa / 1 bar.
IMPORTANT INFORMATION DO NOT add any type of
tire liner or foam fill material to the tires. Excessive loads
created by foam filled tires will cause premature failures.
Only use O.E.M. specified tires.
Hardware
Check daily. Inspect the entire machine for loose or missing
hardware.
Cleaning
Regular cleaning, especially under the mower deck, will
increase the machine’s life-span. Make it a habit to clean the
machine directly after use (after it is cooled), before the debris
sticks.
Do not spray water on the top of the mower deck. Use
compressed air to clean the top side of mower deck. Do not
use a high pressure washer or steam cleaner. Avoid spraying
engine and electrical components with water.
24
MAINTENANCE